Operation Manual

Installing the Driver Software in Novell NetWare
ISDN-Controller C2 – 6 Installing the Driver Software in Novell NetWare 23
6 Installing the Driver
Software in Novell NetWare
Two different drivers are provided for installation in Novell
NetWare 4.11 or higher: a Stand-Alone CAPI and a version for
Novell CAPI Manager. If you would like to use Novell’s CAPI
Manager, the program NIAS (Novell Internet Access Server) is
also required. Make sure that both the CAPI Manager and
NIAS is installed before beginning the AVM ISDN-
Controller C2 installation. Also be sure to observe the differ-
ences in the installation, configuration and removal proce-
dures for the two drivers.
6.1 Preparing the System
Before the driver software installation begins, the server
must be started and the CD-ROM drive mounted. If this is not
the case, proceed as follows:
1. To start the server, go to the installation folder of the
server. Enter the following commands at the command
line:
cd nwserver
server
2. To verify whether the CD-ROM drive is installed, insert
the CD and enter the following command at the system
console:
volume
All mounted volumes are listed.
3. If the volume label of the CD does not appear in the list,
enter the following command at the system console:
cdrom
This mounts the CD-ROM drive. The computer is now ready
for the driver software installation.
c2-e.book Seite 23 Mittwoch, 27. November 2002 3:24 15