Operation Manual

Configuring the ISDN-Controller C2
ISDN-Controller C2 – 5 Installing the Driver Software in Windows NT 4.0 21
By default the ISDN-Controller C2 is loaded automatically
every time Windows NT 4.0 is started. Because the controller
is loaded before the items in the “Startup” program group, it
is no problem to include communications programs based
on CAPI in the “Startup” group.
5.2 Configuring the ISDN-Controller C2
To change the settings for the D-channel protocol and line
type on the S
0
lines, and to activate or deactivate data com-
pression, start the program “C2 Setup” in the “AVM” pro-
gram group. Select the ISDN-Controller C2 and follow the in-
structions displayed.
5.3 Installing Additional ISDN-Controllers
If you would like to add another AVM ISDN-Controller C2, re-
peat the entire installation procedure described above.
1. Begin by installing the hardware (see the chapter
“Hardware Installation” on page 11).
2. Then run the program “C2 Setup” in the “AVM” program
group and select “New (Add an ISDN-Controller)”.
3. Follow the instructions displayed on the screen.
Active AVM ISDN-Controllers for the ISA, PCI and PCMCIA
buses may also be combined in one computer. If you want to
add another active ISDN-Controllers, carry out the controller
installation procedure as described in the appropriate manu-
al, using the installation program on the original disk or
CD-ROM supplied with it.
5.4 Removing the ISDN-Controller C2
Only one ISDN-Controller can be removed at a time. If you
have installed several ISDN-Controllers and want to remove
them all, repeat the above procedure several times. It is not
necessary to restart Windows NT 4.0 between uninstalla-
tions.
c2-e.book Seite 21 Mittwoch, 27. November 2002 3:24 15