Operation Manual

Installing the Driver Software in Windows NT 4.0
ISDN-Controller C2 – 5 Installing the Driver Software in Windows NT 4.0 19
5 Installing the Driver
Software in Windows NT 4.0
Specially developed driver software for Windows NT 4.0 is
supplied with the AVM ISDN-Controller C2. The applications
interface supplied, COMMON-ISDN-API (CAPI) version 2.0,
supports both 16-bit and 32-bit applications. Applications in
DOS windows are not supported. Information on CAPI can
found in the section “The Applications Interface CAPI 2.0” on
page 42.
5.1 Installing the Driver Software
The default settings for the two S
0
lines of the ISDN-
Controller C2 are as follows::
During installation you will have the opportunity to change
the settings for each S
0
interface, or for both S
0
interfaces at
once.
To install the driver software, proceed as follows:
1. Start the computer.
2. Insert the installation CD in your CD-ROM drive.
3. Select “Run” in the Windows NT 4.0 “Start” menu. In
the command line, enter the path to the setup files for
Windows NT:
<CD-ROM drive>:\cardware\c2\windows.nt\
english\setup.exe
You may also click the “Browse” button to search for
the path in the directory list. Confirm by clicking “OK”.
Line type Point-to-multipoint
D-channel protocol DSS1
CAPI SoftCompression active
c2-e.book Seite 19 Mittwoch, 27. November 2002 3:24 15