Operation Manual

Installing Additional ISDN-Controllers
ISDN-Controller C2 – 4 Installing the Driver Software in Windows 2000 17
4.3 Installing Additional ISDN-Controllers
Up to four active AVM ISDN-Controllers can be installed in
your computer. Active AVM ISDN-Controllers for the ISA, PCI,
PCMCIA buses and USB can also be combined in the same
system. If you want to add another active ISDN-Controller,
carry out the controller installation procedure as described in
the appropriate manual, using the installation program on
the original disk or CD-ROM supplied with it.
If you would like to add another AVM ISDN-Controller C2, re-
peat the entire installation procedure described above. Be-
gin by installing the hardware. Then switch on your comput-
er. The “Found New Hardware Wizard” recognizes the new
device. Follow the instructions on the screen.
4.4 Removing the ISDN-Controller C2
Only one ISDN-Controller can be removed at a time. If you
have installed several ISDN-Controllers and want to remove
them all, then perform the procedure described here several
times, without restarting Windows between each operation.
Proceed as follows to remove the AVM ISDN-Controller C2
driver software in Windows 2000:
1. Open the Windows 2000 “Control Panel” (“Start / Set-
tings”) and double-click the “Add/Remove Hardware”
icon.
2. The “Add/Remove Hardware Wizard” is started. Click
“Next”.
3. Select the “Uninstall/Unplug a device” option in the fol-
lowing dialog and click “Next”.
4. Then select the “Uninstall a device” option. Confirm by
clicking “Next”.
5. Select the entry “AVM ISDN-Controller C2” in the follow-
ing list and confirm with “Next”.
6. Confirm the uninstallation by activating the “Yes, I want
to uninstall this device” option and click “Next”.
c2-e.book Seite 17 Mittwoch, 27. November 2002 3:24 15