Operation Manual

Configuring the ISDN-Controller C2
16 ISDN-Controller C2 – 4 Installing the Driver Software in Windows 2000
7. Conclude the installation by clicking “Finish”.
This concludes the ISDN-Controller C2 installation. ISDN-
Controller is now ready for immediate operation.
After installation the CAPI 2.0 and the AVM NDIS WAN CAPI
Driver are available on your system. For details about the
AVM NDIS WAN CAPI Driver and the other two AVM system
drivers, see the section “The AVM System Drivers” on
page 45.
4.2 Configuring the ISDN-Controller C2
The default settings for the two S
0
interfaces of the ISDN-
Controller C2 are as follows:
After the installation has been completed, you can change
the configuration of the ISDN-Controllers's S
0
lines. To con-
figure the ISDN-Controller C2, proceed as follows:
1. Select “Start / Settings / Control Panel / System”. On
the “Hardware” dialog page, click the “Device Manag-
er...” button.
2. Click on the plus sign “+” next to “Network adapters” to
expand the node.
3. Double-click the entry “AVM ISDN-Controller C2” to
open the “Properties” window.
4. On the “S
0
connection” dialog page, you can select the
appropriate line configuration for each of the ISDN-
Controller C2's S
0
lines: point-to-multipoint (“ISDN Ba-
sic Rate Access”), point-to-point (“PBX Line with DDI
(Direct Dial-in)”) or leased line (“Leased line”).
Line type Point-to-multipoint
D-channel protocol DSS1
c2-e.book Seite 16 Mittwoch, 27. November 2002 3:24 15