Operation Manual

Installing the Driver Software in Windows 2000
ISDN-Controller C2 – 4 Installing the Driver Software in Windows 2000 15
4 Installing the Driver
Software in Windows 2000
In Windows 2000, the ISDN-Controller is integrated as a net-
work adapter via the NDIS WAN CAPI Driver and included in
the list of network adapters listed in the Device Manager.
After installation, the CAPI 2.0 interface and the NDIS WAN
interface are available to the entire system; no separate driv-
er installation is required. You can then use CAPI 2.0-based
applications alongside Microsoft's Remote Access Service
(RAS) or Internet access with Dial-Up Networking.
The CAPI 2.0 interface supplied supports both 16-bit and 32-
bit applications. Applications in DOS windows are not sup-
ported. Information on CAPI can found in the section “The
Applications Interface CAPI 2.0” on page 42.
4.1 Installing the Driver Software
To configure the ISDN-Controller C2, proceed as follows:
1. Start the computer.
The “Found New Hardware Wizard” recognizes a new
device to be installed. Click “Next”.
2. In the next window, select the option “Search for a suit-
able driver for my device (recommended)” and confirm
your selection with “Next”.
3. Insert the C2 CD-ROM.
4. In the next window, select the option “CD-ROM drives”
and confirm by clicking “Next”.
5. The program reports that a driver was found. Click
“Next” to install the driver.
6. Enter the multiple subscriber numbers in the “ISDN
MultiSubscriber Number (MSN)” window.
Click “Next”.
c2-e.book Seite 15 Mittwoch, 27. November 2002 3:24 15