Operation Manual

Installing Additional Controllers
14 ISDN-Controller C2 – 3 Installing the Driver Software in Windows XP
3.3 Installing Additional Controllers
Up to four active AVM ISDN-Controllers can be installed in
your computer. Active AVM ISDN-Controllers for the ISA, PCI,
PCMCIA buses and USB can also be combined in the same
system.
If you want to add another active ISDN-Controller, carry out
the controller installation procedure as described in the ap-
propriate manual. The driver software for all installed ISDN-
Controllers is loaded automatically when Windows XP starts.
3.4 Removing the ISDN-Controller C2
Only one ISDN-Controller can be removed at a time. If you
have installed several ISDN-Controllers and want to remove
them all, then perform the procedure described here several
times, without restarting Windows between each operation.
Proceed as follows to remove the AVM ISDN-Controller C2
driver software in Windows XP:
1. Open the “System Properties” of Windows XP by click-
ing through “Start / Control Panel / (in “Category View”:
Performance and Maintenance) / System” and select
the “Device Manager” button on the “Hardware” set-
tings page.
2. In the “Network adapters” section of the “Device Man-
ager”, select the “AVM ISDN-Controller C2” entry.
3. In the “Action” menu, select the “Uninstall” command.
4. Confirm the uninstallation in the following security
prompt. The AVM ISDN-Controller C2 is then removed
from the system.
5. Now switch off the computer and unplug it, then re-
move the ISDN-Controller card.
This concludes the uninstallation of the AVM ISDN-
Controller C2 in Windows XP.
c2-e.book Seite 14 Mittwoch, 27. November 2002 3:24 15