Operation Manual

Hardware Installation
ISDN-Controller C2 – 2 Hardware Installation 11
2 Hardware Installation
The ISDN-Controller C2 hardware is built in to the PC first, be-
fore its driver software is installed.
The ISDN-Controller C2 has two S
0
lines, each of which can
be configured independently. Please note the order of the S
0
lines during installation and configuration (see the figure
page 7).
To install the AVM ISDN-Controller C2, proceed as follows:
1. Switch off your computer and any connected devices
and then unplug the power plug.
2. Open the cover of the PC. Touch the metal of the PC
housing to discharge any static electricity.
3. Choose a PCI slot, unscrew and remove the slot blank-
ing plate at the back of the PC, and insert the ISDN-
Controller C2 in the slot.
If installing the ISDN-Controller in a Novell NetWare
system: note the number of the slot in which you have
inserted the ISDN-Controller C2 for use in the configu-
ration procedure.
4. Screw the back plate of the ISDN-Controller C2 on to the
back panel of the PC.
5. Close the computer housing and plug the power cord
back in to the socket.
6. Connect the S
0
lines to the ISDN socket. The ISDN ca-
bles have an RJ45 plug at each end. Insert one end in
your ISDN socket and the other end in the socket on the
back plate of your ISDN-Controller C2.
This completes the hardware installation.
The individual steps taken to install the driver software differ
among the operating systems. Read the section that de-
scribes the driver installation for your operating system.
c2-e.book Seite 11 Mittwoch, 27. November 2002 3:24 15