Operation Manual

Error messages in Windows 3.x
Controller B1 v3.0 – 16 Troubleshooting 99
Error message: “Error in the configuration file. Incorrect B1
controller type.”
Possible cause: Different types of controllers (ISDN-Control-
lers for the ISA and PCI buses) are combined in your system.
During the installation of the additional controller, the ISDN-
LOAD.CFG and SYSTEM.INI files were not changed correctly.
Remedy: Note the instructions for installing additional con-
trollers in the section for the relevant operating system.
When adding an AVM ISDN-Controller for a different bus
type, the line Type=XX must be added in the ISDNLOAD.CFG
file (“B1at” for ISA controller, “B1pci” for PCI controller). This
change must also be made in the SYSTEM.INI file.
Error message: Interrupt <xx> not available”
Possible cause: The AVM ISDN-Controller B1 v3.0 and anoth-
er hardware device (like a sound card) are set to the same in-
terrupt.
Remedy: Check which interrupts (IRQs) are available in your
system by using the MSD.EXE program in the Windows direc-
tory. Then start the “B1 Setup” program from the “AVM” pro-
gram group and define another interrupt for the ISDN-Con-
troller. Windows must be restarted for these settings to take
effect.
Error message: “Installation error. Internal error: ISDN driver
not loaded.”
Possible cause: The driver file B1CBASE.386 has been moved
or deleted, or the SYSTEM.INI file no longer contains the cor-
responding entry.
Remedy: Run the installation program SETUP.EXE from the
original installation disk.
Error message: The diagnostics program “B1 Test” does not
run in Windows.
Possible cause: The test program was started while the driv-
er software (CAPI) was loaded.
HB_B1V30.book Seite 99 Mittwoch, 7. Februar 2001 3:19 15