Operation Manual

The AVM ISDN-Controller B1 v3.0 on Point-to-Point ISDN Lines
76 Controller B1 v3.0 – 12 The AVM ISDN-Controller B1 v3.0 on Point-to-Point ISDN Lines
12 The AVM ISDN-Controller
B1 v3.0 on Point-to-Point
ISDN Lines
By default, the AVM ISDN-Controller B1 v3.0 is installed with
settings for BRI lines in point-to-multipoint configuration.
To operate the controller with point-to-point lines (also
called direct-dial-in or DDI lines), a number of special set-
tings must be made depending on the operating system
used.
Please note that only one terminal device can be connected
to a point-to-point BRI.
Windows 2000
In Windows 2000 a configuration must be performed in the
Device Manager to operate the AVM ISDN-Controller B1 v3.0
at a point-to-point line. Proceed as follows:
1. Open the Device Manager by clicking it on the “Hard-
ware” settings page (“Start / Settings / Control Panel /
System”).
2. Click the “+” preceding the entry “Network adapters”.
3. Then click with the right mouse button on the entry
“AVM ISDN-Controller B1”.
4. Click the “Properties” option and then go to the “Ad-
vanced” settings page.
5. On this settings page, activate the option “Support for
Point-to-Point ISDN lines (with DDI capability)”.
6. Save your entries with “OK”.
7. The computer must be restarted for this setting to take
effect.
HB_B1V30.book Seite 76 Mittwoch, 7. Februar 2001 3:19 15