Operation Manual

Changing the Settings
Controller B1 v3.0 – 11 Installation in OS/2 73
11.3 Changing the Settings
After installation, the setting for the D-channel protocol may
be changed. Proceed as follows:
Start the INSTALL.EXE program as described in the section
“Installing the Driver Software” on page 70 and follow the in-
structions.
11.4 Installing Additional Controllers
Up to four active AVM ISDN-Controllers and ISDN-Controllers
for the ISA and PCI bus may be combined in one computer.
To install an additional AVM ISDN-Controller B1 v3.0, proceed
as follows:
1. Open the ISDNLOAD.CFG file from the directory of the
driver software, e.g. IDRIVER, in a text editor.
2. Copy the entire section beginning with the line [ISDN-
Controller-00]. Enter the copied section again below the
original section.
3. Then add one to each of the controller numbers in the
new section and enter the desired values for the sec-
ond controller:
– I/O address and interrupt
– Base module (specifies the T4 file): “b1.t4” stands
for the D-channel protocol DSS1, “b1tr6.t4” for 1TR6,
and “b1usa.t4” for NI1 and 5ESS.
– :PROTOCOL (specifies the D-channel protocol):
“\x00” stands for DSS1, “\x06” for 1TR6, “\xo3” for
NI1, and “\x05” for 5ESS
Example:
[ISDN-Controller-00]
IO Address = 150
Interrupt = 5
Base Module = b1.t4
HB_B1V30.book Seite 73 Mittwoch, 7. Februar 2001 3:19 15