Operation Manual

Removing the ISDN-Controller B1 v3.0
62 ISDN-Controller B1 v3.0 – 9 Installation in MS-DOS
The ibase command loads all ISDN-Controllers installed.
9.6 Removing the ISDN-Controller B1 v3.0
To remove the AVM ISDN-Controller B1 v3.0 in MS-DOS, pro-
ceed as follows:
1. First unload the driver with the command ibase -
2. Then use the relevant DOS commands to delete the di-
rectory in which the drive software is located.
3. If the command ibase has been entered in the file
AUTOEXEC.BAT, this file must be changed as well.
This concludes the removal of the AVM ISDN-Controller
B1 v3.0 from MS-DOS.
HB_B1V30.book Seite 62 Mittwoch, 7. Februar 2001 3:19 15