Operation Manual

Installing the Driver Software
38 ISDN-Controller B1 v3.0 – 6 Installation in Windows 98
Use the “F1” key at any time to view a help text for the
current installation step.
Click “Next”.
2. Select the ISDN-Controller to be installed. For informa-
tion about the controllers listed, click the “Info” button.
Click “Next”.
3. In the next window, enter the folder in which the driver
software of the AVM ISDN-Controller B1 v3.0 is to be in-
stalled. When your entries are complete, click “Next”.
4. The next step is to specify the D-channel protocol of
your ISDN line.
Activate the desired option and then click “Next”. The
installation program then copies all files to the speci-
fied folder.
5. Once copying has been completed, a window display-
ing the settings of the ISDN-Controller B1 v3.0 appears.
Confirm these settings by clicking “OK”.
A new folder called “AVM” is created in the “Programs”
group of the Start menu. This folder contains the programs
“AVM Internet Home Page”, “B1 Unload”, “B1 Load”, “B1
Readme”, “B1 Setup” and “B1 Test”.
This concludes the installation of the driver software for the
AVM ISDN-Controller B1 v3.0 in Windows 98.
If the I/O address of the ISDN-Controller must be changed
after installation, because of a new hardware device, for in-
stance, open the Windows 98 Device Manager by clicking
through “Settings / Control Panel / System”. Enter the new
value there.
After changing this setting, remove the ISDN-Controller
hardware from the computer and switch the jumper accord-
ingly. Windows 98 administers the interrupt values automat-
ically.
HB_B1V30.book Seite 38 Mittwoch, 7. Februar 2001 3:19 15