Operation Manual

Mapping an MSN to an EAZ
106 Controller B1 – 17 Support for Multiple Subscriber Numbers (MSNs)
Mapping an MSN to an EAZ
To map an MSN to an EAZ, proceed as follows:
1. Configure your application for a certain EAZ (from 1 to
9). Refer to the application’s manual for instructions. If
the application is configured for the EAZ 0 (zero), it will
respond to all MSNs configured in the system by
MSN.EXE.
2. Load the controller by typing the command
ibase <Return>
at the DOS prompt.
3. Run MSN.EXE to assign an MSN to the EAZ configured in
Step 1. Use the following syntax:
msn -sx=yyyyyyy
where x is the EAZ and yyyyyyy is the desired MSN
Example: To assign the subscriber number 01234567 to
EAZ 5, type at the DOS prompt: msn -s5=1234567.
When this is done you may begin working with the applica-
tion.
The assignment of a given EAZ to an MSN can be canceled ei-
ther by using MSN.EXE or by removing the CAPI driver from
memory.
Displaying EAZ–MSN Mapping
The following command line arguments can be used to dis-
play the current EAZ assignments:
l Display all EAZ assignments.
msn -d
l Displays the MSN mapped to the given EAZ.
msn -d<EAZ>
HB_B1V30.book Seite 106 Mittwoch, 7. Februar 2001 3:19 15