Operation Manual

Error messages in Novell NetWare
104 Controller B1 v3.0 – 16 Troubleshooting
Remedy: First end all applications that use the ISDN-Control-
ler. Then you can unload or uninstall it.
Error message: “Installation error, I/O address <xxx> not
available.”
Possible cause: The I/O address selected during installation
of the ISDN-Controller is used by another hardware device
and is not available.
Remedy: Establish which I/O addresses are available in your
system. Then adjust the position of the jumper on the ISDN-
Controller to match the selected I/O address and enter the
new I/O address in the “b1setup” program. This program is
started by entering load b1setup at the server console.
Error message: “Installation error, Interrupt <xx> not
available.”)
Possible cause: The interrupt set for the AVM ISDN-Controller
B1 v3.0 during installation is not available.
Remedy: Check which interrupts (IRQs) are available in your
system. Enter load b1setup at the server console and set
another interrupt. Then reload the ISDN-Controller.
HB_B1V30.book Seite 104 Mittwoch, 7. Februar 2001 3:19 15