Operation Manual

Error messages in Novell NetWare
102 Controller B1 v3.0 – 16 Troubleshooting
Error messages in Novell NetWare
Error message: “CAPI not loaded.”
Possible cause: You tried to start an ISDN application with-
out loading the AVM ISDN-Controller B1 v3.0 first.
Remedy: Load the Controller B1 v3.0 by entering
load
capi20
at the system console and then start your ISDN ap-
plication.
Error message: “Error in configuration file, no ISDN-
Controller defined.”
Possible cause: During the AVM ISDN-Controller B1 v3.0 in-
stallation, the configuration file CAPI20.CFG is created. If you
later edit this file manually and corrupt the ISDN-Controller
definition(s) it contains, the error occurs.
Remedy: Repeat the complete AVM ISDN-Controller B1 v3.0
installation.
Error messages:
“Deinstallation error, wrong CAPI driver loaded.”
“Installation error, wrong CAPI driver loaded.”
“Installation error, ISDN-Controller-xx unknown keyword
<xx>.”
“Installation error, ISDN-Controller-xx <xxxx> value too
long.”
“Installation error, ISDN-Controller-xx <xxxx> illegal value.”
Possible cause: You have replaced some files in the ISDN-
Controller driver installation directory (on obtaining updated
drivers from the AVM Data Call Center, for example). Older
files in the same directory cause version conflicts.
Remedy: Always perform the full AVM ISDN-Controller
B1 v3.0 installation procedure; never replace individual files.
HB_B1V30.book Seite 102 Mittwoch, 7. Februar 2001 3:19 15