Operation Manual

Error messages in OS/2
Controller B1 v3.0 – 16 Troubleshooting 101
Remedy: Note the instructions for installing additional con-
trollers in the section “Installing Additional Controllers” on
page 60. When adding an AVM ISDN-Controller for a different
bus type, the line Type=XX must be added in the ISDN-
LOAD.CFG file (“B1at” for ISA controller, “B1pci” for PCI con-
troller).
Error messages in OS/2
Error message: “Controller-xx with I/O address <xxx> could
not be found”
Possible cause: The position of the jumper that sets the I/O
address on the ISDN-Controller does not correspond to the
entry in the ISDNLOAD.CFG file, the I/O address is used by
another hardware device (such as a network adapter), or the
hardware is not installed.
Remedy: Check which I/O address is available in your com-
puter and set the jumper on the ISDN-Controller accordingly
(see the section “Setting the I/O Address” on page 14). Then
enter the new I/O address in the ISDNLOAD.CFG file using a
text editor. The computer must be restarted for these set-
tings to take effect. Another option is to simply repeat the in-
stallation of the driver software.
Error message: Interrupt <xx> not available.”
Possible cause: The AVM ISDN-Controller B1 v3.0 and anoth-
er hardware device (like a sound card) are set to the same in-
terrupt.
Remedy: Check which interrupts (IRQs) are available in your
system. Then use a text editor to enter a new interrupt for the
ISDN-Controller in the ISDNLOAD.CFG file. The computer
must be restarted for these settings to take effect. Another
option is to simply repeat the installation of the driver soft-
ware.
HB_B1V30.book Seite 101 Mittwoch, 7. Februar 2001 3:19 15