Operation Manual

18
2 Installation
The B1 Setup program allows you to adjust the settings
for the D channel protocol, automatic loading of the ISDN-
Controller B1 USB and data compression, without
reinstalling the driver software. The document B1 Readme
contains the latest information on the ISDN-Controller
B1 USB. Use the program B1 Test to test your ISDN-
Controller B1 USB for correct installation and working
order.
2.3 Starting the ISDN-Controller; Automatic Loading
If you did not restart Windows at the end of the driver
installation procedure, you may run the program B1
Load in the ”AVM” program group to begin using the
ISDN-Controller B1 USB.
By default, the AVM ISDN-Controller B1 USB is loaded
automatically each time Windows starts up. The ISDN-
Controller is loaded before the Startup program group is
processed, so that you may include CAPI-based ISDN
applications in this group.
The automatic loading mechanism can be deactivated
using the program B1 Setup in the ”AVM” program
group. First unload the ISDN-Controller by running B1
Unload. Then start B1 Setup and change the options in
the dialogs as desired.
Remember to reset your AVM ISDN-Controller B1 USB
by selecting the B1 Load command so that your new
settings take effect.
When you exit Windows, the AVM ISDN-Controller B1
USB is automatically deactivated.
2.4 Plug & Play with the Computer Running
Windows’ Plug & Play capabilities allow you to shut off the
ISDN-Controller B1 USB, or to disconnect it from its
power supply, from the ISDN line or from the USB bus,
without shutting down the computer.