Operation Manual

14
2 Installation
• Insert the floppy disk labeled ”AVM ISDN-Controller
B1 USB, Installation Windows 98/NT 5.0” in your 3.5"
floppy disk drive.
If the driver software was supplied on a CD-ROM,
insert the B1 USB CD in your CD-ROM drive.
• In the next dialog you are asked, ”What do you want
to do?” Select the option ”Search for the best driver
for your device.” Then click on Next.
• In the next dialog the Wizard asks where to search for
the driver software. Select the option corresponding
to the medium supplied, ”Floppy disk drives” or ”CD-
ROM drive”. Click on Next.
• The next dialog notifies you that the driver was
located as follows (these paths are only examples;
the actual paths may vary):
Floppy disk: i.e.: A:\B1USBset.inf
or
CD-ROM: i.e.: D:\Cardware\B1USB\Windows.
98\B1USBset.inf
Click on Next. Windows now copies the Setup files for
the ISDN-Controller B1 USB to a temporary directory
on your hard disk.
• The next dialog announces, ”Windows has finished
installing the software that your new hardware device
requires.” Click on the Finish button.
• To complete the hardware component installation,
the computer must be restarted. Answer Yes at the
corresponding prompt.
If you installed the driver from a floppy disk, remove
it from the floppy drive now.
• After Windows has started again, the sign-on window
of the AVM ISDN-Controller B1 USB appears
automatically. Click on Continue.
• In the next dialog, select the option ”Installation” and
then click on Continue.