Operation Manual

11
2 Installation
2 Installing the AVM ISDN-Controller B1 USB
This chapter describes how to connect the ISDN-
Controller B1 USB to your computer or USB hub and to
your ISDN line, and how to install the driver software. You
may also read how to load and unload the controller
software, how to handle the ISDN-Controller and how to
change the AVM ISDN-Controller B1 USB’s
configuration settings after installation. The chapter
closes with instructions for removing the ISDN-Controller
B1 USB from the system, and with a description of the
NDIS WAN CAPI Driver.
The AVM ISDN-Controller B1 USB is available for the
operating systems Windows 98, Windows NT 5.0 and
Windows 95 (OSR 2.0) with USB extension.
The installation of the AVM ISDN-Controller B1 USB is
performed in two main phases:
1. The ISDN-Controller B1 USB is connected to
• the power supply,
• the computer or USB hub, and
• the ISDN line.
2. The new hardware component and its driver software
are installed in the operating system.
While the first of these phases is the same for all the
operating systems supported, the second is different, as
the operating systems have different procedures for
setting up a new hardware component and installing driver
software. For details, see the corresponding sections
2.2.1, ”Installation in Windows 98 and Windows NT 5.0”
and 2.2.2, ”Installation in Windows 95 OSR 2.1”.
After the driver software has been installed and loaded,
the applications interface COMMON ISDN API (CAP(I ) 2.0
is available to all programs. This CAPI version also
supports the use of CAPI 1.1-based applications. For
more information on the CAPI driver supplied, please see
Chapter 4.