Specifications

Error Messages in Novell NetWare
80 ISDN-Controller B1 PCI v4.0 – 16 Troubleshooting
Error message: “Error in configuration file, no ISDN-
Controller defined.”
Possible cause: During the ISDN-Controller B1 PCI v4.0 in-
stallation, the configuration file CAPI20.CFG is created. If
you later edit this file manually and corrupt the ISDN-Con-
troller definition(s) it contains, the error occurs.
Remedy: Repeat the complete installation of the ISDN-Con-
troller B1 PCI v4.0.
Error Messages:
“Deinstallation error, wrong CAPI driver loaded.”
“Installation error, wrong CAPI driver loaded.”
“Installation error, ISDN-Controller-xx unknown keyword
<xx>.”
“Installation error, ISDN-Controller-xx <xxxx> value too
long.”
“Installation error, ISDN-Controller-xx <xxxx> illegal value.”
Possible cause: You have replaced some files in the ISDN-
Controller driver installation folder (on obtaining updated
drivers from the AVM Data Call Center, for example). Older
files in the same directory cause version conflicts.
Remedy: Always perform the full ISDN-Controller
B1 PCI v4.0 installation procedure; never replace individual
files.
Error message: “Installation error, Controller-xx with I/O
address <xxx> does not answer.”
Possible cause: The ISDN-Controller was not fully loaded or
the hardware is damaged.
Remedy: Repeat the complete installation of the ISDN-Con-
troller. To test the hardware, you may install the ISDN Con-
troller in DOS and then run the program “B1 Test”. In case
of a hardware defect, please contact your dealer or AVM.