Specifications

Starting Operation of the ISDN-Controller B1 PCI v4.0
58 ISDN-Controller B1 PCI v4.0 – 12 Installation in OS/2
12.2 Starting Operation of the ISDN-Controller
B1 PCI v4.0
If you specified during installation of the driver software
that the ISDN-Controller is to be loaded every time the com-
puter is started, the message “Device driver for AVM ISDN-
Controller B1 PCI installed” appears briefly upon start-up.
Loading the ISDN-Controller
The ISDN-Controller can be loaded manually by double-
clicking the “B1 Load” icon in the “AVM” program group. An
OS/2 window is opened and displays the following mes-
sage when the loading procedure is complete:
Unloading the ISDN-Controller
To unload the ISDN-Controller, double-click the “B1 Un-
load” icon in the “AVM” program group. A corresponding
message is displayed.
12.3 Changing the Settings
After installation the D-channel protocol setting can be
changed. Proceed as follows:
Open the program INSTALL.EXE as described in the section
“Installing the Driver Software” from page 56 and follow the
instructions there.
Information on CAPI SoftCompression can be found in the
section “Installing the ISDN-Controller B1 PCI v4.0” on
page 12.
AVM GmbH ISDN-Controller B1 PCI
COMMON-ISDN-API
Version 2.0
E-DSS1/Release xxxxxx
Serial Number xxxxxxx
Address xxx/IRQ x
Add. Service: V.42bis, Fax G3 Polling, DTMF, GSM,
Message after manually loading in OS/2