Specifications

Operation of the ISDN-Controller B1 PCI v4.0 with CAPI for the CAPI Manager
ISDN-Controller B1 PCI v4.0 – 10 Installation in Novell NetWare 6.x, 5.x, 4.x and 3.12
5. In the next window, assign a name to the ISDN-Control-
ler B1 PCI v4.0, for instance B1PCI.
6. Configure the ISDN-Controller in the “WHSMCAPI
Board Configuration” window. Move the highlight to
“Select to View” and press “Return”.
7. When prompted to choose whether the ISDN-Control-
ler should be loaded automatically, select “Yes”.
8. In the next dialog, select the ISDN-Controller “B1PCI”
and press “Return”.
9. Then enter your parameters:
– PCI slot
– Reports (fixed at 2)
– Switch Type (D-channel protocol)
– Line Config (MTP = multipoint or PPT = point-to-
point)
– Automatic Data Compression
Information on CAPI SoftCompression can be found in
the section “CAPI SoftCompression X75/V42bis” from
page 71.
10. Exit the configuration dialog by pressing “Esc” twice
and select “Yes” to confirm that you want to save the
new settings.
11. The final step in the configuration process is to update
the system and load the ISDN-Controller.
In the “Internetworking Configuration” window, select
the “Reinitialize System” command and confirm it by
selecting “Yes”.
12. Exit the configuration by pressing “Esc”. Answer “Yes”
to save your settings.
This concludes the configuration and loading processes for
the ISDN-Controller B1 PCI v4.0 with the CAPI Manager.
The ISDN-Controller B1 PCI v4.0 settings can be changed at
any time using this method.