Specifications

Installing the ISDN-Controller B1 PCI v4.0
12 ISDN-Controller B1 PCI v4.0 – 2 Installing the ISDN-Controller B1 PCI v4.0
2 Installing the ISDN-Controller
B1 PCI v4.0
First install the ISDN-Controller B1 PCI v4.0 hardware in the
computer, before you install the driver software.
Proceed as follows to install the ISDN-Controller
B1 PCI v4.0:
1. Switch off your computer and any connected devices.
Disconnect their power supply.
2. Open the cover of the computer. Touch the metal of the
housing to discharge any static electricity.
3. Choose a PCI slot, unscrew and remove the slot blank-
ing plate at the back of the computer, and insert the
ISDN-Controller B1 PCI v4.0 in the slot.
For installation in Novell NetWare: Note the number of
the slot in which you have inserted the ISDN-Controller
B1 PCI v4.0 for subsequent configuration.
4. Screw the back plate of the ISDN-Controller
B1 PCI v4.0 on to the back panel of the computer.
5. Close the computer housing and plug the power cord
back in to the socket.
6. Connect the ISDN-Controller B1 PCI v4.0 to your ISDN
supply. The ISDN cable has an RJ45 plug at each end.
Insert one end into your ISDN NT and the other end in-
to the S
0
socket on the back plate of your ISDN-Con-
troller B1 PCI v4.0.
This completes the hardware installation.
The individual steps taken to install the driver software dif-
fer among the operating systems. Read the section that
describes the driver installation for your operating system.