Operation Manual

3 Driver Software Installation – MS-DOS

US only: Has your SPID or ISDN directory number

changed? To change the ISDN directory number or the

SPID for the AVM ISDN-Controller A1, run the installa-

tion program again and enter the new number and SPID.

You can also edit the file ISDNLOAD.CFG in the installa-

tion directory by using a text editor. Enter the directory

number(s) and SPID value(s) in the [ISDN-Controller-XX]

section:

:DN = X

:SPID = X

:DN2 = X

:SPID2 = X

3.4.2 Configuring the Controller

The I/O address defined by the jumper position must

correspond with the I/O address entered in the Controller

software. To enter the I/O address, run the program A1

Setup. The following dialog appears on the screen:

A1Setup Version 1.2

Hardware configuration for AVM ISDN-Controller A1

Controller I/O adress: 300

(Values permitted are 200, 240, 300, 340, default is 300)

Controller IRQ level: 5

(Values permitted are 2, 3, 4, 5, 6, 7, 10, 11, 12, 15, default is 5)

Press Ctrl + Home to save

Space = Change value Tab = List

Figure 6 The A1 Setup Program in MS-DOS

Enter the I/O address you chose in the first input field.

The given value can be changed by pressing the space

bar. Press the Tab key to view a list of all possible values.

Select the desired I/O address by moving the highlighted

bar to the desired entry and then press Return.

Enter a new value for the interrupt in the second input

field. Press the space bar or use the Tab key to choose

another value.

Save your entries by pressing Return.

Changing SPID or

Directory No. after

Installation