Operation Manual

22
3 Driver Software Installation – Windows NT
5. Specify the folder in which the driver software is to
be installed.
The default folder is C:\IDRIVER, but any other path
desired may be entered. Once your entries are
complete, click OK.
6. Enter the interrupt (IRQ) for the Controller in the next
window.
Then specify the I/O address under which the Con-
troller is to be managed in the system. Enter the I/
O address which corresponds to the jumper position
on the Controller (see Chapter 2, “Hardware Instal-
lation” and Chapter 4, “Technical Specifications”).
Figure 4 Setting Interrupt and I/O address
7. In the next dialog, specify the D-channel protocol
used by your ISDN line, e.g. DSS1 or a national
protocol.
Select the appropriate protocol type and click Con-
tinue.
US only: The next dialog asks you to enter your first
complete ISDN directory number (area code plus
telephone number) in the first input field. In the
second field, enter your first complete SPID.
In the following dialog box, enter your second
complete ISDN directory number and your second