Operation Manual

Changing the Settings
Controller A1 PCMCIA – 3 Installing the Driver Software in Windows 2000 15
3.2 Changing the Settings
Once installation is completed, you can make changes to the
ISDN-Controller D-channel protocol and the multiple call
numbers. To do this, proceed as follows:
1. Proceed through “Start / Settings / Control Panel / Sys-
tem / ‘Hardware‘ page” and click the corresponding
buttong to open the Device Manager.
2. Click on the “+” in front of the “Network adapters” en-
try.
3. Then use the right-hand mouse button to click on the
“AVM ISDN-Controller FRITZ!Card-PCMCIA” entry.
4. Click on the “Properties” option and go to the “ISDN”
page.
5. On this index, select the D-channel protocol you want
(in Germany DSS1).
6. You can use the “Configure...” button to edit the multi-
ple call numbers for the NDIS WAN CAPI driver.
7. Confirm the settings by clicking “OK”.
The configuration of your controller A1 PCMCIA is then com-
plete.
a1pcm_e.book Seite 15 Mittwoch, 18. Juli 2001 11:22 11