Operating Instructions and Installation Instructions
WLAN Standards
59
Thanks to compatibility with the 802.11g standard, you can
also continue to use older WLAN devices.
Setting the Right Standard in the FRITZ!Box
The throughput rate that can be achieved in your WLAN radio
network depends on the WLAN standards used by the inte-
grated WLAN devices. These WLAN standards must also be
set in the FRITZ!Box. Proceed as follows to check which WLAN
standards are set and change them if needed:
1. Open the FRITZ!Box user interface.
2. Make sure that the expert mode is enabled in the “Sys-
tem / Expert Mode” menu.
3. Open the “WLAN / Radio Channel” menu and select “Ad-
just radio channel settings” to make the desired changes.
• In order to communicate with each other, the FRITZ!Box
and all WLAN devices must work in the same frequency
band.
• The standard you configure in the FRITZ!Box must be
compatible with the standards of all WLAN devices used
in the WLAN.
Make a note of which standards the WLAN devices in your
network are compatible with and then adjust the FRITZ!Box
settings according to the following information:
The use of the 802.11n standard—and thus the availability
of higher throughput rates—is possible only if the WLAN con-
nection is secured using the WPA2 security mechanism (AES-
CCMP).
Note the following for the configuration of this setting:
FB6840LTE-e2.fm Seite 59 Dienstag, 29. Mai 2012 5:34 17