Operation Manual

Assistance From AVM Support
FRITZ!X USB – 8 Support 75
after which FRITZ!fon answers calls can be specified in the
program settings on the “Answering Machine” page over the
“Answering Profile” button. The delay setting in effect is the
one configured in the answering profile that is activated on
the “ISDN” settings page.
FRITZ!X USB after a power failure
When you restart FRITZ!X USB after a power failure, its
configuration corresponds to the last settings saved in the
PBX’s on-board memory. Settings are saved permanently
with the FRITZ!X configuration software.
If you have changed settings but not saved them in
FRITZ!X USB, then FRITZ!X USB starts up with its original
factory settings.
No acknowledgment tone is heard during programming
Only tone-dialing (DTMF) telephones can be used to program
FRITZ!X USB. Pulse-dialing telephones are not suitable for
programming FRITZ!X USB.
Some terminal devices can operate with either tone or pulse
dialing. Check your terminal equipment.
8.4 Assistance From AVM Support
Please use the information sources described above before
contacting the support.
For direct assistance, AVM Support is available to provide
help when problems arise, during installation and your first
steps in operating FRITZ!X USB.
The support desk can be reached by e-mail or by fax. AVM
Support then will contact you to assist in resolving your
problem. You will receive an e-mail or a fax.
Should problems establishing connections arise, please try
to establish a test connection to the AVM Data Call Center
(ADC) before contacting Support. See the instructions in the
F!XUSB-e.book Seite 75 Mittwoch, 8. November 2006 2:23 14