Operation Manual

Continuing the Installation
24 FRITZ!X PC – 3 Software Installation
3.3 Continuing the Installation
The installation procedure for the software components
FRITZ!, AVM ISDN CAPI Port Driver and FRITZ!X is the same in
all operating systems. Proceed as follows:
Installing the FRITZ! Communications Software
1. After driver software for the FRITZ!X PC ISDN-Connector
has been installed, the Setup program reports that the
FRITZ! communications software can be installed. Click
on the “Install” button if you want to install FRITZ!.
2. Specify the folder in which you want to install the FRITZ!
communications software on your computer.
3. Next, specify the program group in which you want
FRITZ! to appear in the Start menu.
4. The next dialog asks you to choose whether you want
just to install the software, or to enter certain configura-
tion settings during the installation.
If you select the simple Installation, the FRITZ! modules
are installed in the specified folder with the default set-
tings. You can adjust the settings for all FRITZ! modules
as needed after the installation. Please read the perti-
nent sections in the FRITZ! manual or see the On-line
Help for instructions.
If you select Installation with Configuration
, you will be
prompted to enter certain basic configuration settings,
including outside dialing settings in case your ISDN line
is itself a PBX extension.
Installing the AVM ISDN CAPI Port Driver
Finally, the Setup program allows you to install the AVM ISDN
CAPI Port Driver. A dialog with three pages appears:
1. On the “Modems” page, select the desired CAPI Port
modems, such as “AVM ISDN Internet (PPP over ISDN)”
for an ISDN connection to an Internet provider using
F!xpc_e.book Seite 24 Dienstag, 16. Oktober 2001 6:07 18