Operation Manual

Hardware Installation
16 FRITZ!X PC – 2 Hardware Installation
2 Hardware Installation
This chapter describes the installation procedure for the
FRITZ!X PC hardware, including the connections to the ISDN
line, the PC and the power supply, as well as instructions for
connecting analog terminal equipment to the PBX.
When the FRITZ!X PC installation has been completed, the
analog extensions (for telephones, fax machines etc.) are
ready to use.
If you want to use the full capabilities of FRITZ!X PC (such as
Internet and ISDN file transfer), you should also install the
corresponding software components. The complete software
installation includes not only the driver software, but also
the FRITZ! communications software and the PBX configura-
tion program FRITZ!X (see the chapter “Software Installa-
tion” on page 19).
The installation is performed in the following order:
1. Verify that the package contents are complete.
2. Install the hardware.
3. Install the software components of FRITZ!X PC.
4. Perform the necessary PBX configuration.
2.1 Where to Install FRITZ!X PC
FRITZ!X PC can be installed on a suitable horizontal or verti-
cal surface. The unit should be installed in a dry, dust-free
place out of direct sunlight. If you want to mount your
FRITZ!X PC on the wall, use the drilling template supplied in
the package.
The extension jacks on the back panel of your FRITZ!X PC
should be readily accessible. Make sure that the connected
cables are not kinked, stretched or otherwise subjected to
mechanical stress.
F!xpc_e.book Seite 16 Dienstag, 16. Oktober 2001 6:07 18