Operation Manual

Always Prepared with “Remote Wake Up”
FRITZ!Card – 4 How Does Work FRITZ!Card 33
Always Prepared with “Remote Wake Up”
Please note the following to keep FRITZ!Card USB v2.1 and
FRITZ! ready to receive at all times in standby operation.
z Deactivate the “hibernation” option. The “Remote
Wake Up over ISDN” command is not available when
the system is hibernating.
z For an incoming call to “wake up” the computer from
standby, at least one ISDN application must indicate to
the CAPI driver that it is ready to receive. Make sure that
a suitable application is started.
z If you operate FRITZ!Card USB v2.1 at a PBX with an in-
ternal S
0
bus, it may not make sense to use standby.
Some PBX systems constantly interrupt standby opera-
tion with internal signals. In such a case, connect your
FRITZ!Card USB v2.1 directly to the S
0
- bus.
The computer will be “woken up” when FRITZ!Card USB v2.1
receives information about an incoming call during standby
(hence the name “Remote Wake Up”). The program checks
the service indicator and phone number of the incoming call;
if a suitable program is active, the call will be accepted.
Depending on the power options set, the computer may re-
turn to standby after checking the call parameters.
FCusb-e.book Seite 33 Dienstag, 12. September 2006 3:12 15