Operation Manual

AVM ISDN CAPI Port Driver Installation
FRITZ!Card – 2 Installing FRITZ!Card USB v2.1 15
Installation with Configuration: A number of basic set-
tings can be made during installation, for example, in-
formation for operation at a PBX.
2.8 AVM ISDN CAPI Port Driver
Installation
Upon conclusion of the FRITZ! communications software in-
stallation, you can install the AVM ISDN CAPI Port Driver. A
window with four settings pages is displayed:
z Modems
Select here the CAPI Port modems you would like to
install, such as “AVM ISDN Internet (PPP over ISDN)” for
a connection to an Internet Service Provider using
Windows’ Dial-Up Networking. View information about
the individual modems by clicking a modem and then
pressing “F1”.
z Ports
On this settings page you can assign specific COM ports
to the virtual modems. Unless your system requires
special port settings, you can simply confirm the de-
fault settings.
z MSN
This setting allows you to separate the online charges
from the charges for voice connections. To use this op-
tion, an MSN must be entered on the “MSN” settings
page. Online connections then will be charged to this
number.
z AVM Test Connection / Fast Internet over ISDN
Define here whether two new connections should be
configured in Dial-Up Networking during installation of
the AVM CAPI Port Driver: AVM Fast Internet and AVM In-
tranet. Dial-Up Networking must already be installed on
your computer.
These connections are only designed to check that the
program functions properly. They cannot be used to es-
tablish a connection to the Internet.
FCusb-e.book Seite 15 Dienstag, 12. September 2006 3:12 15