User manual

10
[425] ISDN Data Link Mode
[426] ISDN TEI Mode
System Restart
After setting the system programming, restart the system. You can restart the system by turning
the Power switch “OFF” and then “ON”.
3. Dial .1. Dial .
NEXTCLR
SYS-PGM NO? →
5. Press .
2. Press NEXT.
NEXTCLRSKP+
Data Link Mode
SE
NEXTCLRSKP+
Port NO?
→
NEXTSEL+ →
#1 :Call
4. Press SEL+ and then
press .
STORE
<If Your Contract is
Point-to-Multipoint>
NEXTSEL+ →
#1 :Permanent
<If Your Contract is
Point-to-Point>
OR
4. Press .
STORE
2 54
END
1
NEXTCLR
SYS-PGM NO? →
2. Press NEXT.
NEXTCLRSKP+
TEI Assign
SE
NEXTCLRSKP+
Port NO?
→
NEXTSEL →
#1 :Automatic
<If Your Contract is
Point-to-Multipoint>
NEXTSEL →
#1 :Fix 0
<If Your Contract is
Point-to-Point>
OR
STORE
4. Press .
4. Press and then
press CLR, and then
press .
STORE
SHIFT
1. Dial .
2
1
6
1
4
5. Press .
END
3. Dial .
1
1
Basic Programming