Operation Manual

6 Konfiguration der FRITZ!Card

Fig. 4 FRITZ!Card with Jumper set to I/O Address 300

2. To set a new I/O area (I/O address), simply reposition the

jumper.

Make sure that the new value is not already being used by

another plug-in card.

3. Now physically install FRITZ!Card in your computer. Fol-

low the instructions from the relevant sections of Chapter

3 “How to Install FRITZ!Card”.

Setting the jumper position directly on the card is thus finished.

Then enter the changed I/O area (I/O address) in the driver software

or continue with the installation (see relevant section in Chapter 3

“How to Install FRITZ!Card”).

ISDN-Buchse

gesteckter Jumper

I/O-Address 200

I/O-Address 240

I/O-Address 300

I/O-Address 340

Steckplatz-

blech