Operation Manual

3 Installation der FRITZ!Card – Windows 3.x

3.3.1Changing the Settings in the Software

Changing the D channel protocol and data compression

If you wish to subsequently change the D channel protocol or

the settings for data compression, run the installation program

for FRITZ!Card again.

Changing the I/O address and the interrupt in the software

If you wish to subsequently change the value for the I/O ad-

dress or the interrupt in the software, start the FRITZ!Card Setup

program in the AVM program group. The following input mask

appears:

Fig. 3 Input Mask

All available I/O addresses and interrupt values are displayed

in the dialog box when you click on the small arrows. Enter the

value for the I/O address in the upper box. Select the value which

you have set by positioning the jumper directly on the card.

Enter the interrupt in the lower dialog box.

Click on OK to save your settings. You must restart the com-

puter for the changes to take effect.