Operation Manual

3 Installation der FRITZ!Card – Windows 3.x

2. Installing FRITZ!Card in the PC

• After checking and, if necessary, changing the jumper posi-

tion on FRITZ!Card, installation of FRITZ!Card is now car-

ried out. Before performing the installation, switch off the

PC and all other connected units and pull out the power

plugs.

• Loosen the screws of the PC housing and open the PC.

• Select an appropriate slot, remove the slot plate on the top

end and insert FRITZ!Card into the selected slot.

• Screw FRITZ!Card tightly to the top end of the slot.

• Close the computer, tighten the screws and reconnect the

power plugs. The installation of FRITZ!Card is now com-

pleted.

3. Connecting FRITZ!Card to ISDN

• FRITZ!Card must now be connected to the ISDN. Take the

cable supplied with the card and insert the plug into the

FRITZ!Card socket.

• Simply insert the other end of the cable into the ISDN socket.

4. Installing the FRITZ!Card Driver Software

Once FRITZ!Card has been installed in the PC and connected to

ISDN, the next step is to install the FRITZ!Card driver software.

• Start your PC.

• Insert the FRITZ!Card CD into your CD drive and call up the

FRITZ!Card CD introduction by double-clicking on the file

INTRO.HLP in the root directory of the CD.

• On the welcome page of the introduction, click on the icon

for FRITZ!Card and on the next page, click on the Windows

3.x icon.

• On the following page, click on the icon ISDN-Controller

FRITZ!Card and then on the following page, click on the Start

installation icon.