Operation Manual

3 Installation der FRITZ!Card – Windows NT

3.2 Installation in Windows NT 4.0 (Workstation i386)

You have the facility to install FRITZ!Card with the aid of the

introduction contained on the CD. This introduction guides you

through the installation procedure and gives you installation

instructions.

Start the CD introduction by going into the Explorer and double-

clicking on the file INTRO.HLP in the root directory of the

FRITZ!Card CD.

To install the driver software for FRITZ!Card in Windows NT 4.0, you

must have administrator rights.

Note that before installing the FRITZ!Card driver software, it is abso-

lutely essential that you install the current Microsoft Service Pack on

your computer. You can obtain this software directly from Microsoft.

FRITZ!Card is installed on your computer by means of a detailed

installation program. Installation is performed in four main

steps:

1. Setting the I/O area (I/O address) on FRITZ!Card

2. Installation of FRITZ!Card in the PC

3. Connection of FRITZ!Card to the ISDN

4. Installation of the driver software for FRITZ!Card

With Windows NT it is absolutely essential to observe the sequence

of the installation steps. If you fail to follow the specified sequence,

error-free operation of FRITZ!Card is not guaranteed.

The procedure for installing FRITZ!Card is as follows:

1. Setting the I/O Area (I/O Address) on FRITZ!Card

• In the first step of installation before installing FRITZ!Card

in your computer, make sure that a free interrupt and a free

I/O area (I/O address) are available.

• FRITZ!Card is set to 5 for the interrupt and to 300 for the I/O

area. If you wish to use an I/O area for FRITZ!Card which

deviates from the preset value on the card, it is necessary to