Operation Manual

3 How to Install FRITZ!Card – Windows 95
16
2. Setting the I/O Area (I/O Address) on FRITZ!Card
• In the second step of installation, if necessary, change the
jumper position for the I/O area (I/O address) on FRITZ!Card.
Use the value displayed in the hardware wizard. For how to
change the jumper position, see Chapter 6 “Setting the I/O
Area (I/O Address) on FRITZ!Card”.
3. Installing FRITZ!Card in the PC
• After installing the software for the hardware component and
setting the jumper position on FRITZ!Card, the third step of
installation is carried out: installing FRITZ!Card into your PC.
Loosen the screws of the PC housing and open the PC.
• Select an appropriate slot, remove the slot plate on the top
end and insert FRITZ!Card into the selected slot.
• Screw FRITZ!Card tightly to the top end of the slot.
• Close the computer, tighten the screws and reconnect the
power plugs. The installation of FRITZ!Card is now com-
pleted. FRITZ!Card must now be connected to the ISDN.
4. Connecting FRITZ!Card to ISDN
• For the fourth step of installation, take the cable supplied
with the card and insert the plug into the FRITZ!Card socket.
• Simply insert the other end of the cable into the ISDN socket.
5. Installing the FRITZ!Card Driver Software
Once FRITZ!Card has been installed in the PC and connected to
ISDN, the fifth step is to install the FRITZ!Card driver software.
• Switch your computer back on. When Windows 95 starts, the
welcome window of the setup program appears. Click on
Next. You can quit the installation procedure at any time by
means of the Exit button.
• In the following window, select the Installation option and
click on Next.
• In the next window, specify the folder in which you wish to
install the FRITZ!Card software. The default is C:\IDRIVER.