Operation Manual

Installing the USB Drivers for FRITZ!Box Fon WLAN in Mac OS X
FRITZ!Box Fon WLAN – 2 Starting FRITZ!Box Fon WLAN Operation 37
Installing the USB Drivers for FRITZ!Box Fon
WLAN in Mac OS X
1. Select “System Preferences / Network”. You receive the
message that a new port, “Ethernet port en<No.>”, was
found. Confirm the message by clicking “OK”.
2. Under “Show”, select the new port found, “Ethernet
port en<No.>”.
3. Confirm your entries with “Activate Now”.
4. Please see the instructions in the section “Opening the
User Interface” on page 38.
Installing the USB Drivers for FRITZ!Box Fon
WLAN in a Linux Operating System
You have to be logged in as root to make the necessary set-
tings.
The example of SUSE Linux 9.1 is used here to describe how
to install FRITZ!Box Fon WLAN to the USB port in Linux.
1. Open the YaST Control Center.
2. Select the option “Network Devices” and click “Network
Card.
3. The “Network cards configuration” dialog appears.
4. Select “Other (not detected)” and the “Configure...”
button.
5. The device type of the network in the “Manual network
card configuration window should be set toEther-
net”. Select the “USB” check box as well and click
“Next”.
6. In the next dialog, “Network address setup”, select the
“Automatic address setup (via DHCP)” option. Click
“Next”.
7. For “Network cards to configure” select “Other (not de-
tected)”. Then click “Configure...”.