Operation Manual

Installing the Driver Software in Windows 2000
26 BlueFRITZ! AP-X – 3 Software Installation
8. Next you will be prompted to reboot the computer. Click
“Yes”.
The computer will be restarted automatically.
This concludes the installation of the BlueFRITZ! AP-X PBX.
AVM BlueFRITZ! AP-X is now ready for immediate operation.
Then a message appears reporting that the FRITZ! communi-
cations software can be installed. Click the “Install” button,
and skip ahead to the section “Installing the Communica-
tions Software FRITZ!” on page 29.
3.4 Installing the Driver Software in
Windows 2000
Administrator rights are required to install the driver soft-
ware in Windows 2000.
Proceed as follows to install the driver software:
1. After connecting BlueFRITZ! AP-X, start your computer.
The Windows Plug & Play mechanism automatically de-
tects the BlueFRITZ! AP-X PBX. The “Found New Hard-
ware Wizard” is started.
2. Now you are prompted to specify a D-channel protocol.
“European ISDN (DSS1)” is already selected. Confirm
this selection by clicking “Next”.
3. If desired, enter your ISDN line’s multiple subscriber
numbers in the “ISDN Multisubscriber Numbers” win-
dow. Click “Next”.
Remember that the MSNs configured here are valid
only for WAN connections, RAS and Internet access.
These settings have no effect on other software that us-
es the CAPI 2.0 interface.
The driver software for BlueFRITZ! AP-X that is included
with Windows 2000 is now installed.