Operation Manual

Hardware Installation
10 BlueFRITZ! AP-ISDN – 2 Hardware Installation
2 Hardware Installation
This chapter describes the installation of the hardware, that
is, how to connect BlueFRITZ! AP-ISDN to ISDN and thus also
to the power mains.
2.1 Preparing for Installation
BlueFRITZ! AP-ISDN can be installed on any suitable horizontal
or vertical surface. The unit should be installed in a dry, dust-
free location out of direct sunlight. Two cables with different
lengths are supplied to connect BlueFRITZ! AP-ISDN. These al-
low you to select the optimum location to set up BlueFRITZ!
AP-ISDN for Bluetooth connection, no matter where the NT is
located. If you would like to mount BlueFRITZ! AP-ISDN at an
elevated position on a smooth surface, use the double-sided
adhesive tape included in the package.
2.2 Connecting BlueFRITZ! AP-ISDN to ISDN
Proceed as follows:
1. Connect BlueFRITZ! AP-ISDN to a socket of your ISDN line.
2. If you do not want to connect BlueFRITZ! AP-ISDN direct-
ly to the NT, use the 6-meter ISDN cable.
3. Make sure that the ISDN terminal (NT) is connected to the
power supply. The NT supplies BlueFRITZ! AP-ISDN with
power via the ISDN cable.
4. The “Power” LED on BlueFRITZ! AP-ISDN lights up and
the device is ready for operation.
BlueFRITZ! AP-ISDN does not have an on/off switch. The
“Power” LED remains on continuously.
BlueFRITZ! AP-ISDN is now connected. No further installation
steps are necessary.