Specifications

Error Messages in OS/2
ISDN-Controller B1 PCI v4.0 – 14 Troubleshooting 77
Error Messages in OS/2
Error message on loading the controller: “ISDNLOAD: PCI
configuration error: no IRQ allocated.”
Possible cause: There are no IRQs available to the PCI bus.
Remedy: Run your BIOS setup (see the PC or the mainboard
manual) and release at least one free IRQ for use by PCI
adapters.
Example (Award BIOS): BIOS main menu, “PnP/PCI
Configuration”, “IRQ x assigned to: PCI/ISA PnP”.
If you combine adapters without plug-and-play support (Leg-
acy) such as the AVM ISDN-Controller B1 v3.0 in the same
system with PCI or ISA plug-and-play cards, the resources
(I/O addresses and IRQ levels) used by the hardware without
plug-and-play support should be so designated in the com-
puter’s BIOS.
Error Messages in Novell NetWare
Error message on loading the controller: “Installation Error.
Interrupt <xx> not available.”
Possible cause: There are no IRQs available to the PCI bus.
Remedy: Run your BIOS setup (see the PC or the mainboard
manual) and release at least one free IRQ for use by PCI
adapters.
Example (Award BIOS): BIOS main menu, “PnP/PCI
Configuration”, “IRQ x assigned to: PCI/ISA PnP”.
If you combine adapters without plug-and-play support (Leg-
acy) such as the AVM ISDN-Controller B1 v3.0 in the same
system with PCI or ISA plug-and-play cards, the resources
(I/O addresses and IRQ levels) used by the hardware without
plug-and-play support should be so designated in the com-
puter’s BIOS.
HB_B1V40-e.book Seite 77 Freitag, 24. September 2004 4:41 16