Specifications

Installing Additional Controllers
56 ISDN-Controller B1 PCI v4.0 – 10 Installation in Windows OS/2
10.4 Installing Additional Controllers
Up to four active AVM ISDN-Controllers may be installed in
one system.
To add another AVM ISDN-Controller B1 PCI v4.0, open the
ISDNLOAD.CFG file from the driver software directory (de-
fault: IDRIVER) in a text editor.
Copy the following section:
[ISDN-Controller-00]
:PROTOCOL= \xxx
Then switch off the computer and install the second ISDN-
Controller. Subsequent loading procedures will load all in-
stalled controllers.
Active AVM ISDN-Controllers for the ISA, PCI, PCMCIA buses
and USB can also be combined in the same system. When
registering an ISA controller in the ISDNLOAD.CFG file, also
define the I/O address and interrupt level of the ISA control-
ler and add the line Type=B1. For more information, see the
manual for the ISA controller or the corresponding Readme
file.
The “B1 Load” program loads all the controllers installed.
10.5 Removing the ISDN-Controller B1 PCI
v4.0
To remove the AVM ISDN-Controller B1 PCI v4.0 in OS/2, start
the installation program from the original CD.
The program reports that an installed controller was found.
Select the “Uninstall” option in the next window and follow
the instructions on the screen.
The entries in the CONFIG.SYS file made during installation
are deleted.
Restart the computer to conclude the deinstallation of the
driver software.
HB_B1V40-e.book Seite 56 Freitag, 24. September 2004 4:41 16