Specifications

Installing Additional Controllers
50 ISDN-Controller B1 PCI v4.0 – 9 Installation in Linux
Version ppp-2.3.11-24 or higher of the Generic PPP Stack
(pppd) is required for Internet access
. These versions are in-
cluded in all operating system packages from SUSE 6.4.
Proceed as follows to establish a test connection:
1. Start a console (command prompt).
2. Establish a pppd connection with the following com-
mand:
pppd call isdn/avm usepeerdns
For extensions with outside dialing access “0”, use the
following command:
pppd call isdn/avm numberprefix 0
usepeerdns
Once the test connection has been established, the output
window contains the PING transit time to the AVM server over
your ISDN-Controller. This means that installation was suc-
cessful.
Now you can start a web browser and access the AVM home
page. Enter www.avm.de/en.
Pre-defined scripts for dialing into different Internet Service
Providers over the console are included in the AVM software
package.
9.3 Installing Additional Controllers
Up to four active AVM ISDN-Controllers can be installed in your
computer. Active AVM ISDN-Controllers for the ISA, PCI, PCMCIA
buses and USB can also be combined in the same system. It is
not possible to use active and passive AVM ISDN-Controllers
(like FRITZ!Card PCI) at the same time. If you would like to use
an AVM DSL-Controller in addition to the ISDN-Controller B1 PCI
v4.0, the AVM DSL-Controller must be installed last.
To install an additional active AVM ISDN-Controller, simply
perform the installation for the desired controller again. An
individual configuration (D-channel protocol and line type)
can be assigned to each ISDN-Controller.
HB_B1V40-e.book Seite 50 Freitag, 24. September 2004 4:41 16