Specifications

Configuring the ISDN-Controller B1 PCI v4.0 with Stand-Alone CAPI
40 ISDN-Controller B1 PCI v4.0 – 8 Installation in Novell NetWare 6.x, 5.x, 4.x and 3.12
To enter the driver software for the CAPI Manager, enter
the following command:
<CD-ROM DRIVE>\CARDWARE\B1_PCI\
NETWARE\4CAPIMGR\ENGLISH
7. Confirm with “Return”.
8. In the next step, select “Install on this server” and
press “Return”.
The files for the AVM ISDN-Controller B1 PCI v4.0 are
now copied to the SYS:\SYSTEM directory.
The README file for the AVM ISDN-Controller B1 PCI v4.0
is displayed on the screen, concluding the installation.
9. Press “Esc” to close the display.
10. Press “Esc” as often as necessary to close all sub-
menus and return to the “Configuration Options” menu.
11. Select “Exit” to leave the installation program.
See the following sections for information about how to start
operation and configure the ISDN-Controller with Stand-
Alone CAPI.
To use the CAPI Manager, read further under “Configuration
of the ISDN-Controller B1 PCI v4.0 with CAPI for the CAPI Man-
ager” on page 42.
8.2 Configuring the ISDN-Controller B1
PCI v4.0 with Stand-Alone CAPI
To configure the AVM ISDN-Controller B1 PCI v4.0 with Stand-
Alone CAPI, enter at the system console:
load b1setup
A list of available ISDN-Controllers with their I/O addresses,
interrupts and D-channel protocols appears. Use the cursor
keys to select the controller to be configured from this list
and then press “Return”.
The configuration window for the AVM ISDN-Controller B1 PCI
v4.0 appears. Here you can perform the settings for the D-
channel protocol, the Point-to-Point protocol (Direct Dial-In)
HB_B1V40-e.book Seite 40 Freitag, 24. September 2004 4:41 16