Specifications

Changing the Settings
36 ISDN-Controller B1 PCI v4.0 – 7 Installation in Windows 98
7.2 Changing the Settings
After installation has been concluded, you have the option of
changing the following settings of the ISDN-Controller B1 PCI
v4.0:
z D-channel protocol: DSS1 (Euro ISDN), NI1, 5ESS, 1TR6
z activate automatic data compression (CAPI SoftCom-
pression X75/V42bis)
Open the “B1 Setup” program from the “AVM” program
group and follow the instructions there.
Information on CAPI SoftCompression can be found in the
section “CAPI SoftCompression X75/V42bis” on page 66.
7.3 Installing Additional Controllers
Up to four active AVM ISDN-Controllers can be installed in
your computer. Active AVM ISDN-Controllers for the ISA, PCI,
PCMCIA buses and USB can also be combined in the same
system.
To install an additional ISDN-Controller for the PCI bus, sim-
ply insert it in a suitable slot as described in “Installing the
ISDN-Controller B1 PCI v4.0” on page 12 and start Windows.
Make your settings in the dialogs as described in the section
“Installing the Driver Software” on page 33. That’s all!
If you want to add another active ISDN-Controller, carry out
the controller installation procedure as described in the
appropriate manual. USB devices such as the B1 USB are
recognized by the Plug & Play mechanism.
The driver software for all installed ISDN-Controllers is load-
ed automatically when Windows starts.
HB_B1V40-e.book Seite 36 Freitag, 24. September 2004 4:41 16