Specifications

Installing Additional Controllers
22 ISDN-Controller B1 PCI v4.0 – 4 Installation in Windows 2000
4.3 Installing Additional Controllers
Up to four active AVM ISDN-Controllers can be installed in
your computer. Active AVM ISDN-Controllers for the ISA, PCI,
PCMCIA buses and USB can also be combined in the same
system.
To install an additional ISDN-Controller for the PCI bus, sim-
ply insert it in a suitable slot as described in “Installing the
ISDN-Controller B1 PCI v4.0” on page 12 and start Windows.
Make the entries described in the section “Installing the
Driver Software” on page 19. That’s all!
If you want to add another active ISDN-Controller, carry out
the controller installation procedure as described in the ap-
propriate manual. USB devices such as the B1 USB are recog-
nized by the Plug & Play mechanism.
The driver software for all installed ISDN-Controllers is load-
ed automatically when Windows 2000 starts.
4.4 Removing ISDN-Controller B1 PCI v4.0
Proceed as follows to remove the AVM ISDN-Controller B1 PCI
v4.0 driver software in Windows 2000:
1. Select “Start / Settings / Control Panel”, then double-
click the “Add/Remove Hardware” icon.
2. The “Add/Remove Hardware Wizard” is started. Click
“Next”.
3. Select the “Uninstall/Unplug a device” option in the fol-
lowing dialog and click “Next”.
4. Then select the “Uninstall a device” option. Confirm by
clicking “Next”.
5. In the next dialog, the device to be removed must be se-
lected. Activate the option “Show hidden devices”.
Select the entry “AVM ISDN-Controller B1 PCI”. Click
“Next”.
6. Confirm the uninstallation by activating the option “Yes,
I want to uninstall this device” and click “Next”.
HB_B1V40-e.book Seite 22 Freitag, 24. September 2004 4:41 16