Specifications

Changing the Settings
ISDN-Controller B1 PCI v4.0 – 4 Installation in Windows 2000 21
7. Reboot the computer.
After installation the CAPI 2.0 and the AVM ISDN NDIS WAN
CAPI Driver are available on your system. For details about
the AVM ISDN CoNDIS WAN CAPI Driver and the other two
AVM system drivers, see the section “The AVM System Driv-
ers” on page 64.
4.2 Changing the Settings
After installation is concluded, you have the opportunity to
change the D-channel protocol and the MSNs of the ISDN-
Controller. To do so, proceed as follows:
1. Select “Start / Settings / Control Panel / System”. On the
“Hardware” dialog page, click the “Device Manager...”
button.
2. Click the plus sign “+” next to “Network adapters” to
expand the node.
3. Click the entry “AVM ISDN-Controller B1 PCI” with the
right mouse button.
4. Click the “Properties” command and select the “ISDN”
page.
5. Select the desired D-channel protocol on this settings
page and then click the “Configure...” button to enter
the Multiple Subscriber Numbers for the NDIS WAN
CAPI Driver.
If the current driver software from AVM is installed on your
system, the “Device Manager” includes an additional “Ad-
vanced” settings page which allows you to activate Direct
Dial-in.
HB_B1V40-e.book Seite 21 Freitag, 24. September 2004 4:41 16