Specifications

Installing Additional Controllers
16 ISDN-Controller B1 PCI v4.0 – 3 Installation in Windows XP
4. Click the “Properties” command and select the “ISDN”
page.
5. Select the desired D-channel protocol on this settings
page and then click the “Configure...” button to enter
the Multiple Subscriber Numbers for the NDIS WAN
CAPI Driver.
If the current driver software from AVM is installed on your
system, the “Device Manager” includes an additional “Ad-
vanced” settings page which allows you to activate Direct
Dial-in.
3.3 Installing Additional Controllers
Up to four active AVM ISDN-Controllers can be installed in
your computer. Active AVM ISDN-Controllers for the ISA, PCI,
PCMCIA buses and USB can also be combined in the same
system.
To install an additional ISDN-Controller for the PCI bus, sim-
ply insert it in a suitable slot as described in “Installing the
ISDN-Controller B1 PCI v4.0” on page 12 and start Windows.
Make the entries described in the section “Installing the
Driver Software” on page 14. That’s all!
If you want to add another active ISDN-Controller, carry out
the controller installation procedure as described in the ap-
propriate manual. USB devices such as the B1 USB are recog-
nized by the Plug & Play mechanism.
The driver software for all installed ISDN-Controllers is load-
ed automatically when Windows XP starts.
HB_B1V40-e.book Seite 16 Freitag, 24. September 2004 4:41 16